KEY FEATURES
• Ideal for motorsport use
• Acts as a safety device to allow quick escape from the vehicle
• Allows space for the driver to comfortably exit the car where the seat cannot be adjusted
• Fits almost any vehicle, welding to steering column is required
• The hub fit to a standard racing wheel with 3 hole fitment USA Standard 3x 40mm PCD (such as Longacre/Rebco/JOES/any of our range of 3 hole american lightweight racing wheels)

DESIGN
• Anodised billet aluminium for corrosion resistance
• Hardened to be harder wearing against the steel hex
• ID of spline/hex is 3/4" (19mm) to fit most steering columns
• 3 x M8 threaded holes for attachment to wheel
• Ultra lightweight item, only 245g

INSTALLATION
1. Included is the centre weld on hex, the aluminium hub and the three M8 cap screws.
2. Slide the centre hex fully over a 3/4" OD steering column and tack weld to hold in place.
3. When hed is tacked in place, fully weld around ensuring a strong attachment to the column.
4. Bolt the 3 hole steering wheel to the hub.
5. Push the release button and slide the hub onto the hex and release the button ensuring the hub clicks on.
6. To release, push the button and pull the wheel towards the driver.

Installation of this product should be done by a qualified professional. Welding must be done to a high standard to avoid safety concerns.